Greetings All,
My first post here.
I am building the Nutube preamp kit and may have a packaging error.
I have begun the assembly of my preamp kit and on confirming the parts selection to the instruction sheet document I may have found a discrepancy.
The write up states that the jfets Q1 and Q2 are different and packaged accordingly.
However I have found that while the Q1 package contained 4, FKH35 J113 fets, the Q2 package contained 2, of FKH35 and 2, of WH44 J113 fets.
This raised a red flag for me and I would like some guidance on whether this is a packaging error or is there more detail needed on how to populate the PCB correctly?
All of their respective bias resistors checked out consistent at 149 ohms.
No response from the store at this time after asking about a week back.
Thanks for your guidance.
My first post here.
I am building the Nutube preamp kit and may have a packaging error.
I have begun the assembly of my preamp kit and on confirming the parts selection to the instruction sheet document I may have found a discrepancy.
The write up states that the jfets Q1 and Q2 are different and packaged accordingly.
However I have found that while the Q1 package contained 4, FKH35 J113 fets, the Q2 package contained 2, of FKH35 and 2, of WH44 J113 fets.
This raised a red flag for me and I would like some guidance on whether this is a packaging error or is there more detail needed on how to populate the PCB correctly?
All of their respective bias resistors checked out consistent at 149 ohms.
No response from the store at this time after asking about a week back.
Thanks for your guidance.